Minimize development efforts and save time and money with the product
introduction of PROFINET RT into your device - KUNBUS-IC offers a
simple option to integrate ProfiNet RT (PROFINET slave device) into your
device with maximum efficiency.
Our KUNBUS-IC modules not only
have the required PROFINET RT interface, but also an interface to your
control. A standard pin-out permits realization of all of our buses by
simple replacement of the module type. The KUNBUS-IC modules naturally
have all the necessary components like optoelectronic coupler, bus
driver, and microcontroller, bus components, and the indispensable
memory. Furthermore, KUNBUS-IC modules have proven themselves in the
security field, have been tested 100 %, and naturally are PNO-certified.
of the KUNBUS-IC module to the processor of your control for
implementation of PROFINET KUNBUS-IC RT (PROFINET KUNBUS-IC IRT as COM
module) can be realized with a UART interface. A shift register
interface can be used for devices without a processor. The signal
distribution (32x8 bytes) to the input and output registers is done as
required. This permits, for example, a split into 5x input and 27x
output. Via a second serial CDI interface, a terminal can be connected,
for example, as a debugging and configuration interface. A galvanic
separation of up to 1.5 kV between the bus interface and control has
also been realized on the module. Because the KUNBUS-IC PROFINET module
can be operated independent of the control, the load of the processor of
the control is fully reduced.