Home > CAN Hardware > CAN Bus Converter >

PLIN-LWL
PLIN-LWL Fiber-optic Converter
 
PLIN-LWL CAN wire to fiber-optic converters, IPEH-004049
Our Price: $1,099.00

Availability: Usually Ships in 1 to 2 Weeks
Qty:

Description Technical Specs Downloads
 
PEAK-System has developed the PLIN-LWL to allow the use of LIN field bus in areas subject to explosion hazards or to electromagnetic susceptibility (e.g. during EMI/EMC measurements). This system can be used to substitute a segment of the electrical LIN bus by fiber optic cable. A PLIN-LWL set contains two converter modules and a duplex fiber optic cable with standard ST connectors.

The electromagnetic compatibility of a converter module can be optimized by hardware configuration. At bit rates of up to 10.4 kbit/s, an electrical LIN transmission is possible with signal edges being less steep. Another measurement to improve EMC is the use of the implemented linear voltage regulator (instead of the switching regulator) for input voltages up to 20 Volts. A converter module is supplied either via the low-voltage input (e.g. for the supplied mains adapter) or via a separate pin on the D-Sub connector.
Features
  • Bit rates from 2.4 kbit/s up to 20 kbit/s
  • TJA1028 LIN transceiver
  • LED display for power supply and transceiver status
  • Switchable master termination
  • LIN bus connection via D-Sub, 9-pin
  • The fiber-optic line consists of a 62.5/125 µm fiber-optic duplex line with ST connectors
  • Supply voltage: 8 – 30 V
  • Supply via D-Sub 9-pin or DC connector (jumper)
  • Aluminum casing
  • Extended operating temperature range from -40 to 85 °C (-40 to 185 °F)

Related Products
PCAN-LIN Interface (low-speed) PCAN-LIN Interface (high-speed CAN) PCAN-LIN Interface (high-speed/iso)
Our Price: $355.00
Our Price: $355.00
Our Price: $429.00
PCAN-LIN CAN-to-LIN Interface PCAN-LIN CAN-to-LIN Interface PCAN-LIN CAN-to-LIN Interface